Real Fiero Tech

Check where the wiring passes through the door jamb. The wires can break in the harness where they flex when opening and closing the door. It can cause an intermittent open circuit.

Steve

It's not mine. I frequented this site when I was building my Rx7. The bellhousing looked familiar, so I thought I would show some of the guy's other work.

Steve

http://www.grannysspeedshop.com/

Check out the shop mule section


Steve

http://www.renegadehybrids.com/


Steve

Stalker V8

http://www.bruntonauto.com/


Steve

The bars include all links and mounts.


Steve

I need to get rid of what's left of my old Emod autocross car. 1 set Quickor sway bars for 84-87. 1 1/8 front, 7/8 rear. $100 1 pair stock rear control arms with Herb Adams mono ball bearings installed. $50 1 pair of unused clutch discs for Tilton 7.25 dual disc clutch. 1"x14 spline. $50 1 Buic...

I've been running a T5 in my 400 sbc powered RX7 for several years. I drive it almost every day, and drag race it occasionally. The engine makes 330 whp and 400wtq. With the 100 shot of nitrous, it dynoed at 440whp and 560wtq. It's been holding up just fine.

Steve

All manual transmission rx7s had hydraulic clutches. Alot of helpful information on v8 rx7 swaps can be found here;

http://www.v8rx7forum.com/forum.php


Steve

IRS quickchange from Speedway Engineering.

http://www.1speedway.com/irs_quickchange.htm#stockcar

Steve

Remove the big round black cap in the bell housing that covers the shift interlock. Remove the the shift interlock assembly, be cafeful there are spring loaded ball in it. Once the interlock is off, you will see one of the shift rails has a bushing around it. Pry the bushing out and the case should ...

Will, look really close at the casting in the last picture.

Steve

I replace the clutch in a 348 a while back. It took about an hour and a half. The 348's clutch is located at the rear of the gearbox. First, you remove the muffler, then unbolt and remove the clutch housing. Sure beats having to split the car in half to replace a wear item.

Steve

Aaron wrote: I could run almost the entire course in 1st gear (Up to about 40-45mph)

Sounds like you had a Miata driver design the course.

Steve

My SBC powered RX7

V8 +15
Longitudinal +25
1 carb +10
2 doors +25
RWD +25
Manual +20
Japanese +1
Origin-Mixed Japanese/American +100
Horsepower +25
21 to 30 years +20
1 ash tray +5

Total=271

Steve

It's like the TRD supercharger on my 2000 Tundra. It's hard to see unless you're looking for it.

Steve

It's on page 154 of the 2008 SCCA solo rule book. The Oldsmobile 442 HO w41 is on the exclusion list for stock class cars. In other words, it's too good to race in the stock classes.

Steve

http://www.derondausa.com/

Steve

Most 180* headers use slip on collectors. The slip fit is usually pretty tight. A large rubber mallet is generally required to install the collectors.

Steve

This would make an interesting swap.

http://www.autobloggreen.com/2007/03/06 ... an-diesel/


Steve