Here are some pictures and a video:
Click here for the video:
Falconer Racing Springs for 60 degree v6.These valve springs came from Falconer Racing:
http://www.falconerengines.com/
They raced the 60* engines back in the late '80s, early '90s. I am told they were run in competition with approximately 0.560 lift.
At 1.570" installed height, the springs seat pressure is 170#. This would be awesome for any hydraulic roller setup. The highest spring pressure I want to go on my 3.4 PR engine is around 120#.
The AERA documents state that the stock installed height for the 2.8L Fiero engine is 1.560" (39.624MM).
It also states that the installed height for the 3.4L Camaro v6 is 1.570" (39.878MM).
So, if you want to run them at 1.7" like some people suggest, you sure can but I go by what AERA says.
At 1.7" installed height these springs run 155#.
I am asking $100 shipped or best offer for the springs and retainers.
Stock spring is to the right of the perf. spring:
The titanium retainers sell for around $30 a piece brand new, and here you get a full set of 12 PLUS some very nice heavy duty springs.
If you have any questions, please don't hesitate to ask!
------------------
Top Line Group Automotive
-Aftermarket accessories for the Fiero
www.TLG-auto.com