pretty neat setup, I'd like to see how he drives the reversed heads cams.
http://www.h1v8.com/page/page/1562068.htm
'busa V8?
Moderator: ericjon262
-
- Posts: 2960
- Joined: Mon May 24, 2010 5:34 pm
- Location: Aiken, SC
'busa V8?
"I am not what you so glibly call to be a civilized man. I have broken with society for reasons which I alone am able to appreciate. I am therefore not subject to it's stupid laws, and I ask you to never allude to them in my presence again."
-
- Posts: 2908
- Joined: Thu Dec 20, 2007 2:47 pm
- Location: Columbus, Ohio
Re: 'busa V8?
Is this related to the Radical SR8 engine, or are there two people doing Hayabusa V8s?
-
- Posts: 2960
- Joined: Mon May 24, 2010 5:34 pm
- Location: Aiken, SC
Re: 'busa V8?
I don't think they are the same, this guy is based in Milwaukee.
"I am not what you so glibly call to be a civilized man. I have broken with society for reasons which I alone am able to appreciate. I am therefore not subject to it's stupid laws, and I ask you to never allude to them in my presence again."
-
- Posts: 2908
- Joined: Thu Dec 20, 2007 2:47 pm
- Location: Columbus, Ohio
Re: 'busa V8?
This globalization thing is pretty crazy. That's why I asked.
-
- Peer Mediator
- Posts: 15679
- Joined: Wed Nov 24, 2004 11:13 pm
- Location: In the darkness, where fear and knowing are one
- Contact:
Re: 'busa V8?
I believe the Radical unit has a 75 degree bank angle.
-
- Peer Mediator
- Posts: 15679
- Joined: Wed Nov 24, 2004 11:13 pm
- Location: In the darkness, where fear and knowing are one
- Contact:
Re: 'busa V8?
I think the Radical and the couple of others I've seen just use a timing chain at each end of the engine.ericjon262 wrote: I'd like to see how he drives the reversed heads cams.
An engine like this using Honda K-series cylinder heads would be a monumental beast... but I4 engines for cars tend to have very small bore centers, and thus need a lot of stroke to get decent displacement. This makes the engine highly stressed at high RPM.
But I don't know of any modern I4's which have a decently large bore center like the Quad 4 or BMW's S14.
Nissan has had a 2.5 I4 on the market for a while, right? I've been generally impressed with that mill when renting Altimas. I'll have to look up the bore and stroke. Anyone know how well that head flows?