Ported lower and Middle intake mani's

Shaun41178(2) · Post by **Shaun41178(2)** » Wed Nov 02, 2005 11:04 pm

Fully ported.

Lower is ported all the way through and gasket matched. Injector holes are slightly enlarged and countoured for a smooth flow.

Middle intake is ported up about 5 inches and all casting flaws have been removed and the transitions smoothed. Also gasket matched to the upper plenum as well.

I wish I could get pics but I will see if I have any old ones laying around I can post. But I can't take any new ones.

If any of you have seen any of my previous port work then you know I do a good and thorough job. Only best quality stuff as I was planning on using these parts on my engine so I didnt' shortcut anything. Many hours spent porting and smoothing and matching all the runners as close as I could to being equal via the ole eyeball.

You get the lower and the middle. If not fully satisfied I will refund your money.

$250 plus actual shipping for both peices. As you can see I am cleaning house.

Shaun41178(2) · Post by **Shaun41178(2)** » Wed Nov 02, 2005 11:13 pm

pics. Bad quality but its all I got. I have really good pics of the ported dual tb, but it wouldnt' be a true pic of what you would be getting however it would show the quality port work but not sure if I should post it.

Shaun41178(2) · Post by **Shaun41178(2)** » Sun Nov 06, 2005 12:47 am

anyone?

spread the word on other forums

dgzfiero · Post by **dgzfiero** » Sun Nov 06, 2005 9:45 pm

How much would shipping be to 73135?
Hell I'll take them anyways.
You can PM how you want the payment.
Doug

stimpy · Post by **stimpy** » Sun Nov 06, 2005 10:54 pm

dgzfiero wrote:How much would shipping be to 73135?
Hell I'll take them anyways.

Cuz that's the way Doug rolls... :afrocool:

Shaun41178(2) · Post by **Shaun41178(2)** » Sun Nov 06, 2005 11:36 pm

I'll pm you. thanks