Fiero Stuff For Sale
Moderator: crzyone
-
- Posts: 316
- Joined: Wed Aug 10, 2005 2:35 pm
- Location: Indiana
The intake is a modified stock peice from a 81 Citation 2.8. The plenum was opened up and an adapter was welded to the top. The carb has been setting for years and may need to be rebuilt. I used the S10 distributor with this setup. I'll make you a package deal, $60 for the headers, carb&manifold, and dist.
Steve
Steve
1985 Mazda RX7 w/400 sbc
Removed it's soul, Gave it some balls.
Removed it's soul, Gave it some balls.
-
- Posts: 316
- Joined: Wed Aug 10, 2005 2:35 pm
- Location: Indiana
Hey -- I might be interested in the Clutch setup if it would fit my Q4 transmission (the getrag 282). I don't like how my Q4 slave and Fiero MC play together, and something like this might be an alternative.
'87 BMW M6 / '88 BMW M5 / '90 Audi Coupe Quattro / '88 Fiero GT 2.3L Quad4 - 400whp; pump gas
-
- Peer Mediator
- Posts: 15624
- Joined: Wed Nov 24, 2004 11:13 pm
- Location: In the darkness, where fear and knowing are one
- Contact:
The bearing is pressed into the sleeve and a spacer is pressed in and welded on both sides of the bearing. the welds would have to be ground out to replace the bearings. They are equipped with grease zerks and I have kept them well lubricated.
Steve
Steve
1985 Mazda RX7 w/400 sbc
Removed it's soul, Gave it some balls.
Removed it's soul, Gave it some balls.
-
- Posts: 316
- Joined: Wed Aug 10, 2005 2:35 pm
- Location: Indiana