Is it possible, does it really need the 3400 intake, therefore not allow for a distributor? It is possible Im just not sure how much custom wrok is needed. any tips.
FIERO5 is your god!
negatives for all.
How do I get gen 3 heads to fit my 2. 8
Moderators: The Dark Side of Will, Series8217
-
- cant get enough of this site!
- Posts: 3289
- Joined: Wed Mar 30, 2005 2:37 pm
-
- cant get enough of this site!
- Posts: 3289
- Joined: Wed Mar 30, 2005 2:37 pm
- Shaun41178(2)
- Posts: 8373
- Joined: Fri Nov 19, 2004 7:12 pm
- Location: Ben Phelps is an alleged scammer
Dude I am going to have to nicely ask you to start asking one question per post and keep all questions in the same post instead of starting new posts for each group of questions.
And to answer the question for this post, if you want to use heads that are of the Gen 2 or the Gen 3 design, you WILL need to change the pistons in that al block of yours.
If you want to use the aluminum heads that you got with the small valves that are iron head look alikes, then no piston change will be necessary. But of course they wont' flow that well.
And to answer the question for this post, if you want to use heads that are of the Gen 2 or the Gen 3 design, you WILL need to change the pistons in that al block of yours.
If you want to use the aluminum heads that you got with the small valves that are iron head look alikes, then no piston change will be necessary. But of course they wont' flow that well.
-
- cant get enough of this site!
- Posts: 3289
- Joined: Wed Mar 30, 2005 2:37 pm
- Shaun41178(2)
- Posts: 8373
- Joined: Fri Nov 19, 2004 7:12 pm
- Location: Ben Phelps is an alleged scammer
-
- cant get enough of this site!
- Posts: 3289
- Joined: Wed Mar 30, 2005 2:37 pm
-
- Peer Mediator
- Posts: 15630
- Joined: Wed Nov 24, 2004 11:13 pm
- Location: In the darkness, where fear and knowing are one
- Contact:
All the basics are at www.60degreev6.com