Put some new goodies on the GTI
Posted: Tue Dec 30, 2008 5:28 pm
My second gear was grinding because of a synchro problem, so we tore it apart at work to replace the synchros and while it was out I decided to buy myself a Christmas present and we put in one of these:
Sorry about the watermark, I pulled it from the website at work. It's a limited slip from Peloquin's.
And while it was up on the lift I put on the rear swaybar I picked up at the end of the summer, two days before I went back to school. It's a Neuspeed 28mm solid bar.
It's kinda grainy because I left my camera at my apartment so I had to use my phone. You can also sorta see the suspension too. It's a Weitec 60/40 cup kit.
Here's a side shot for fun.
And because I ran across it on my computer, here is a scan of my dyno run from last summer (179.85HP 206.08TQ). Since then I added a cold air intake. Even though it's probably only good for 3HP or so, it sounds sweet.
Sorry about the watermark, I pulled it from the website at work. It's a limited slip from Peloquin's.
And while it was up on the lift I put on the rear swaybar I picked up at the end of the summer, two days before I went back to school. It's a Neuspeed 28mm solid bar.
It's kinda grainy because I left my camera at my apartment so I had to use my phone. You can also sorta see the suspension too. It's a Weitec 60/40 cup kit.
Here's a side shot for fun.
And because I ran across it on my computer, here is a scan of my dyno run from last summer (179.85HP 206.08TQ). Since then I added a cold air intake. Even though it's probably only good for 3HP or so, it sounds sweet.