FS: Falconer Racing Cylinder Heads
Moderator: crzyone
-
- Posts: 798
- Joined: Fri May 13, 2005 10:08 pm
- Location: Minnesota
- Contact:
FS: Falconer Racing Cylinder Heads
On Ebay now:
http://cgi.ebay.com/ebaymot...em&item=150353222391
These are designed for any GM iron block 60 degree v6.
Let me know if you have any questions. These are very trick, rare heads.
------------------
Top Line Group Automotive
-Aftermarket accessories for the Fiero
www.TLG-auto.com
-
- Posts: 798
- Joined: Fri May 13, 2005 10:08 pm
- Location: Minnesota
- Contact:
Re: FS: Falconer Racing Cylinder Heads
The following Flow information was taken from here:
http://realfierotech.com/phpBB/viewtopic.php?t=2930
These are very rare heads, with rare titanium intake valves. Check out this flow chart of falconer heads vs. stock heads. Specifically the exhaust side is much better at all lift points, and a person running forced induction would greatly benefit from these.
Also, these flow numbers were taken before the valve job was done:
http://realfierotech.com/phpBB/viewtopic.php?t=2930
These are very rare heads, with rare titanium intake valves. Check out this flow chart of falconer heads vs. stock heads. Specifically the exhaust side is much better at all lift points, and a person running forced induction would greatly benefit from these.
Also, these flow numbers were taken before the valve job was done: