pictures are for example of the measurement I'm looking for. both sides would be awesome.
88 cradle measurement help
Moderators: The Dark Side of Will, Series8217
-
ericjon262
- Posts: 2824
- Joined: Mon May 24, 2010 5:34 pm
- Location: Aiken, SC
88 cradle measurement help
if someone with a manual installed in an 88 cradle could measure the distance from the cradle frame rails to the output of a five speed transmission (bonus points if it's an F23) I would appreciate it more than you could imagine.
pictures are for example of the measurement I'm looking for. both sides would be awesome.
pictures are for example of the measurement I'm looking for. both sides would be awesome.
"I am not what you so glibly call to be a civilized man. I have broken with society for reasons which I alone am able to appreciate. I am therefore not subject to it's stupid laws, and I ask you to never allude to them in my presence again."
-
The Dark Side of Will
- Peer Mediator
- Posts: 15626
- Joined: Wed Nov 24, 2004 11:13 pm
- Location: In the darkness, where fear and knowing are one
- Contact:
Re: 88 cradle measurement help
My '88 has the front end up right now; I might get it back down next weekend.
-
Shaun41178(2)
- Posts: 8368
- Joined: Fri Nov 19, 2004 7:12 pm
- Location: Ben Phelps is an alleged scammer
Re: 88 cradle measurement help
I can prob do it
FieroPhrek working on that ls4 swap for 18 years and counting now. 18 years!!!!! LOL
530 whp is greater than 312
530 whp is greater than 312
-
Shaun41178(2)
- Posts: 8368
- Joined: Fri Nov 19, 2004 7:12 pm
- Location: Ben Phelps is an alleged scammer
Re: 88 cradle measurement help
My axle is still in so measureing from the esge of that axle seal wont happen.
However I measured from the flat surface next to the seal. I got 18.25 inches.
Thats where your 30 cm mark is at on your ruler. As I measured to the inside of the rail.
However I measured from the flat surface next to the seal. I got 18.25 inches.
Thats where your 30 cm mark is at on your ruler. As I measured to the inside of the rail.
-
ericjon262
- Posts: 2824
- Joined: Mon May 24, 2010 5:34 pm
- Location: Aiken, SC
Re: 88 cradle measurement help
Awesome, I assume you measured at approximately the axle centerline height to the top of the inside of the rail?
I appreciate the help!
I appreciate the help!
"I am not what you so glibly call to be a civilized man. I have broken with society for reasons which I alone am able to appreciate. I am therefore not subject to it's stupid laws, and I ask you to never allude to them in my presence again."