Torque Converter 'Mistake'

General Fiero Maintenance including oil changes, air filters, suspension refreshes, restorations, painting, etc.

Moderators: The Dark Side of Will, Series8217

Post Reply
Starlite528
Posts: 316
Joined: Sun Jul 16, 2006 6:02 am
Location: Dallas, Texas
Contact:
Contact Starlite528

Torque Converter 'Mistake'

Post by Starlite528 »

And it's a mistake I will never make ever again.

ALWAYS ALWAYS ALWAYS unbolt the torque converter from the flywheel BEFORE you pull the engine. I put a nice gouge in the sleeve on the end of the converter. I got very lucky today; the local transmission shop popped it out and put a new one in for me free of charge.
Despite millions of dollars in research, Death continues to be our nations number one killer.
Henry Gibson - Kentucky Fried Movie.

Image
http://www.lordshadowstar.com
Top
The Dark Side of Will
Peer Mediator
Posts: 15708
Joined: Wed Nov 24, 2004 11:13 pm
Location: In the darkness, where fear and knowing are one
Contact:
Contact The Dark Side of Will

Post by The Dark Side of Will »

Dump a couple quarts of oil too?

Yes, always remove the convertor from the flexplate. Life is easier that way.
Top
Weponhead
Posts: 446
Joined: Sun Sep 04, 2005 11:38 pm
Contact:
Contact Weponhead

Post by Weponhead »

|| little bit :afrocool: sall good if it got fixed
Image
Top
Post Reply

Return to “Fiero Maintenance”