88 rear sway bar bushings

jelly2m81 · Post by **jelly2m81** » Tue Oct 23, 2007 8:28 pm

Anyone know of a source for the 88 rear inner sway bar bushings?

Thanks!

Shaun41178(2) · Post by **Shaun41178(2)** » Tue Oct 23, 2007 9:18 pm

stock rubber ones?

jelly2m81 · Post by **jelly2m81** » Wed Oct 24, 2007 1:45 am

Shaun41178(2) wrote:stock rubber ones?

rubber or poly, it don't matter to me.

Series8217 · Post by **Series8217** » Thu Nov 01, 2007 3:49 am

summit has poly. measure the bar. its either 22mm or 23mm. i forget.

Steve25 · Post by **Steve25** » Thu Nov 01, 2007 11:11 am

Same solution for the front? And a follow on question. What is the factory front sway bar diameter for an 88 GT? 1.1", 28 mm?

jelly2m81 · Post by **jelly2m81** » Sat Nov 03, 2007 11:01 am

Oh, I forgot to mention this. I made a set of rear sway bar bushings, I used a set of Moog thermoplastic rubber sway bar bushings from a late model Cavalier with a 22 mm bar.

Not a direct replacement, but 5 minutes at the bench grinder was all it took to grind down the center to fit in the stock bracket, and trim a little off the bottom. The Cavalier bushing is a bit beefier, but it is large enough to shape it so that it has shoulders on either end to hold it in place like the stock bushings.

I'll try and remember to take the camera to the shop and get a pic.

Series8217 · Post by **Series8217** » Tue Nov 06, 2007 4:13 pm

Steve25 wrote:Same solution for the front? And a follow on question. What is the factory front sway bar diameter for an 88 GT? 1.1", 28 mm?

Yes, 28mm is the size of the front swaybar for all 88 Fieros.