Adapting a Q4 FWD trans for use with the Fiero 60 degree V6

[fieromadman]

Does anyone have a mostly complete shim set for this trans? OR does anyone know if those chrysler part numbers will work for this trans?

[p8ntman442]

Parts:

Input shaft seal: 3732S
Axle Seals: 3543 (same as Getrag)
Shift shaft seal: 3667

Input shaft inner bearing: SET4 (Timken); A4 (general industry)
Output shaft inner bearing: SET5 (Timken); A5 (industry)
BOTH outer bearings: 15101 (Cone) & 15245 (Cup)
Diff carrier bearings: SET11 (Timken); A18 (industry) (Same as Getrag)

Information from:
http://www.timken.com/industries/automo ... talog.aspx

The input shaft shims have been discon by GM.
Several Chrysler transmissions use them, so they should be available from Chrysler for some time now.

Code: Select all

Input Inner Bearing (SET4) Shims
Chrysler P/N's
P/N          Thickness
04202751     0.62mm
04202301     0.66
04202302     0.70
04202303     0.74
04202304     0.78
04202305     0.82
04202306     0.86
04202307     0.90
04202308     0.94
04202309     0.98
04202310     1.02
04202311     1.06
04202312     1.10
04202313     1.14
04202314     1.18
04202315     1.22
04202316     1.26
04202317     1.30
04202318     1.34
04202319     1.38
04202320     1.42
04202321     1.46
04202322     1.50
04202323     1.54
04202324     1.58
04202325     1.62
04202326     1.66
04419650     1.70
04202753     1.74
04202754     1.78


Diff (SET11) & Output Inner Bearing (SET5) Shims
Shim dimensions:2.421 OD     2.165 ID
Chrysler P/N's
P/N          Thickness
04883546AA   0.42
04883545AA   0.46
05222345     0.50
05222346     0.54
05222347     0.58
05222348     0.62
05222349     0.66
05222350     0.70
05222351     0.74
05222352     0.78
05222353     0.82
05222354     0.86
05222355     0.90
05222356     0.94
05222357     0.98
05222358     1.02
05222359     1.06
05222360     1.10
05222361     1.14
05222362     1.18
05222363     1.22
05222364     1.26
05222365     1.30
05222366     1.34
05222367     1.38
05222368     1.42
05222369     1.46
05222370     1.50
05222371     1.54
05222372     1.58

The diff shim dimensions are 55mm (2.165) ID, 61.5mm (2.421) OD.
These shims are useable on BOTH the diff AND the output shaft of the Muncie.