What you can't see is that 80% of the openings are clogged .....
Size comparison between stock and the 600hp Griffin
Test fit the radiator on the stock cushions and all looked good...
Put the shroud in and despite a little interference with the sway bar all was still looking good...
And it's always the things you DIDN'T see coming are what gets you.... I tried closing the hood and the bottom of the V8Archie hood vent impacts the top of the shroud fan housing...
Trimming back the top of the fan would result in maybe two supports being removed and bringing the fan very close to the hood opening...
The Shroud depth is 2.5" so I can probably trim the entire perimeter of the shroud back.... definitely a hiccup and lots of messy abs cutting with a dremel but doable....
Any other ideas please chime in....
Any other ideas?