Sell your parts/cars here. Parts & Cars - not just for "partscars."
Moderator: crzyone
Shaun41178(2)
Posts: 8464 Joined: Fri Nov 19, 2004 7:12 pm
Location: Ben Phelps is an alleged scammer
Post
by Shaun41178(2) » Mon Dec 18, 2006 8:06 pm
yes these are 3.1 pistons for a 40 over motor. meanign ti would have to be bored out .040 over.
I also have a brand new 3.1 crank too I can sell you with the pistons.
teamhavok2
Posts: 111 Joined: Tue Nov 07, 2006 11:01 am
Location: chico, CA
Post
by teamhavok2 » Fri Apr 13, 2007 9:11 am
with a stock 86 GT what all would be involved in putting in these pistons, and would it be worth it on an older motor? Would it deminish the life of the motor?
Silver 85 GT-scratch that
Maroon and sliver 86 GT
Project Life
Series8217
1988 Fiero Track Car
Posts: 5989 Joined: Thu Jun 02, 2005 9:47 pm
Location: Los Angeles, CA
Post
by Series8217 » Fri Apr 13, 2007 1:39 pm
You have to bore out the motor.
Basically if you rebuild the motor you can install these.
The Dark Side of Will
Peer Mediator
Posts: 15629 Joined: Wed Nov 24, 2004 11:13 pm
Location: In the darkness, where fear and knowing are one
Contact:
Post
by The Dark Side of Will » Fri Apr 13, 2007 2:51 pm
Dont forget that little issue of needing a different crankshaft.
Shaun41178(2)
Posts: 8464 Joined: Fri Nov 19, 2004 7:12 pm
Location: Ben Phelps is an alleged scammer
Post
by Shaun41178(2) » Sat Aug 25, 2007 1:52 pm
now only $90 shipped!!!!!!!
Pyrthian
Posts: 628 Joined: Fri Jun 10, 2005 11:35 am
Location: Detroit, MI
Post
by Pyrthian » Tue Nov 27, 2007 8:34 am
still have? will you seperate?
I broke one of mine during assembly
Pyrthian
Posts: 628 Joined: Fri Jun 10, 2005 11:35 am
Location: Detroit, MI
Post
by Pyrthian » Tue Nov 27, 2007 9:48 am
oops- didnt notice they was 0.40 over
Pyrthian
Posts: 628 Joined: Fri Jun 10, 2005 11:35 am
Location: Detroit, MI
Post
by Pyrthian » Tue Nov 27, 2007 12:14 pm
:thumbleft:
yes - if only....but that WILL require a rebalance.....
with ebverything else I am doing right now, just dont wanna slop anymore on the plate.....