Page 1 of 1

WTB: V6 Cruise / Evap vacuum pipe.

Posted: Sat Mar 20, 2010 4:39 am
by jelly2m81
Looking for a rust free vacuum pipes that connects the cruise servo and Evap purge valve to the engine. It's the 2 small pipes boted to the engine side of the trunk wall.

85-88 V6 is all the same I believe.

Re: WTB: V6 Cruise / Evap vacuum pipe.

Posted: Sun Mar 21, 2010 9:59 pm
by fierogt28
Jelly2m8, that 87GT I had that is now at the dump...you should take a look at it if its still there. Maybe those vaccuum tubes are still good.

Just an option bud... :good:

Re: WTB: V6 Cruise / Evap vacuum pipe.

Posted: Mon Mar 22, 2010 12:20 am
by jelly2m81
fierogt28 wrote:Jelly2m8, that 87GT I had that is now at the dump...you should take a look at it if its still there. Maybe those vaccuum tubes are still good.

Just an option bud... :good:

Those were rusty, hence why they didn't make it on your car. Plus that chassis has been crushed, I went to see if that 85 GT I sent was still there to get the door seals off of it and the owner said he had already crushed the Fiero's.

Re: WTB: V6 Cruise / Evap vacuum pipe.

Posted: Tue Apr 06, 2010 7:22 pm
by fierogt28
jelly2m81 wrote:
fierogt28 wrote:Jelly2m8, that 87GT I had that is now at the dump...you should take a look at it if its still there. Maybe those vaccuum tubes are still good.

Just an option bud... :good:

Those were rusty, hence why they didn't make it on your car. Plus that chassis has been crushed, I went to see if that 85 GT I sent was still there to get the door seals off of it and the owner said he had already crushed the Fiero's.

Holy Christ, that reminds me...I should of taken off those door seals off of the 87GT. IIRC, those were in good shape. :wink:

Re: WTB: V6 Cruise / Evap vacuum pipe.

Posted: Wed Apr 07, 2010 2:53 am
by Emc209i
... Well.. I didn't want to say anything, but no one's speaking up. I've got a set, but I'm in the middle of a swap, and don't know how far the plenum's going to be from the cruise servo. If I decide not to use them, I'll offer them up to you. Aren't you in the Northwest though? Shipping would be rough.

Re: WTB: V6 Cruise / Evap vacuum pipe.

Posted: Wed Apr 07, 2010 6:10 am
by jelly2m81
Emc209i wrote:... Well.. I didn't want to say anything, but no one's speaking up. I've got a set, but I'm in the middle of a swap, and don't know how far the plenum's going to be from the cruise servo. If I decide not to use them, I'll offer them up to you. Aren't you in the Northwest though? Shipping would be rough.

Keep me in mind, I'm in no rush the ones on the wife's car look a little scabby where the brackets are but no signs of leaking yet.

Eastern Canada but don't think shipping would be ridicolous. I'm not lowlx, I can afford cheeseburgers!