Page 1 of 1

Real F@cking Quite

Posted: Sun Sep 08, 2013 8:06 pm
by Identity Crisis
Is it always like this? Very little activity on this board.

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 3:31 am
by jelly2m81
Eliminate drama whores , dumb fucks, and retards and WALLA!

Kinda nice huh?

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 8:28 am
by Series8217
Most of us have been in Fieros for 10+ years and our cars are mostly complete, so we're not working on them every day.

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 8:59 am
by The Dark Side of Will
I like a high signal to noise ratio

We also have extensive archives which chronicle a lot of builds and discuss many, many topics.

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 12:41 pm
by Emc209i
What did you want to talk about?

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 4:45 pm
by crzyone
The forum is QUIET even lol...

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 5:32 pm
by Aaron
It is a very quite forum. Even quiet I'd say! Most of the posts are far more in depth, advanced, and helpful than those over there. Or on any other forum for example. I can't remember when the last time someone asked which exhaust is best on the Jeep forums. That's because I never go there anymore because I'm sick of reading about which exhaust is best.

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 5:36 pm
by Aaron
Check out this thread:

http://realfierotech.com/phpBB/viewtopi ... =9&t=17811

Problem solved in just a few posts. Every post was insightful, and offered a logical suggestion of something that could easily have caused my problem. I dare you to ask the same question on piffer. You'll have 10 replies, all with illogical suggestions of something idiotic. I almost guarantee you someone would tell me it's my fuel pump. 99% of fuel pump failures are catastrophic.

Re: Real F@cking Quite

Posted: Mon Sep 09, 2013 5:57 pm
by Identity Crisis
OK got me I spelled Quite, and it was quite wrong to do when I meant Quiet, like a door mouse.

Re: Real F@cking Quite

Posted: Tue Sep 10, 2013 3:42 am
by Emc209i