Real Fiero Tech

3.1 liter iron head pistons. Approx 8.8:1 compression ratio.

These have the coated skirts and are the Federal mogul ones.

H562CP with a 40 overbore.

$90 shipped. REtails for $180

BRAND NEW. SAVE 30%

offers?

I dont' think I am going to ever use these as compression would be just way too high.

Buy these.

Those are good pistons. Someone should buy those.

ttt

Shaun, could you find out what the shipping to Germany would be?

My address:

Timo Penrod
Am Trieb 10
63579 Freigericht 4
Germany

What is best to use in this situation? USPS? UPS? Fed Ex?

Check with the post office for surface mail. I don't need them in a hurry just as cheap as possible for a customers car.

Shaun do you have any of the other pieces needed for a 3.1 Stroker? Connecting rods, rings, crank shaft, main bearings or rod bearings? Or know someone who does?

I have a set of rods and a brand new 3.1 crank. If I was to ship all that, I would have to package everything separate. At least the crank. The pistons are still on the rods I have, but any machine shop can take care of that.

Let me know how much you want for everything.
I need to clear it with my customer and then I can pay you for it.
I hope you accept PayPal?

I do accept paypal yes. I have a brand new 3.1 crank, rods, new 3.1 iron head pistons, and the flywheel? Is that what you want/need?

Yes that is what I would need. The sleeve bearings and other little pieces I can get else where if you don't have them. So how much total?

you may not need the rods. 2.8/3.1/3.4 rods are all the same. you shipping costs go by weight, so dropping the rods may save some shipping weight. but, if the pistons are already on the rods, the $ you save on shipping, shaun would probably have to charge to press the rods back off the rods.

The pistons aren't on the rods. The rods I have though still have old 2.8 pistons on them. so you would need to press off the 2.8 pistons, and presson the 3.1 pistons.

But yes you can still use your stock rods unless you need an extra set.

Let me know.

I'll ask my customer what he wants to do.

still have them

Part of my rebuild. My fiero went under the sacramento river and now needs to be redone. These pistons would work on the stock motor?

if you are doing a 2.8 they wont' work. If doing a 3.1 then they will work.

so it needs to be bored out? This sounds like what my roomate was talking about. He rebuilds motors every day for a living (restoring old cars). once you open up the engine I'm close to screwed. everything around it and the original concept I understand